Test if it worksĪ simple way to test if your Z-Wave climate device is working is to use Developer Tools -> Services. Note: In the example above, the word Off is encased in single quotes to be valid YAML. For the Remotec ZXT-120, you must instead make a service call like the following. Generally, in Home Assistant, you can use the homeassistant.turn_off service to turn devices off. automation:Įntity_id: climate.remotec_zxt120_heating_1_idĮntity_id: climate.remotec_zxt120_heating_1_39 The following examples will instruct a Remotec ZXT-120 to turn the attached device mode to Heating, and set the temperature at 24 degrees after 8pm. sensor.remotec_zxt120_temperature_38: A sensor which returns the current temperature set on the attached device.climate.remotec_zxt120_heating_1_id: Allows you to control the connected device.The following entities are created for a Remotec ZXT-120. Once enabled, any Z-Wave climate devices will be available to Home Assistant. If the thermostat supports different operating modes, you will get one thermostat entity for each mode. Thermostats with support for fan modes or different operating modes, will be handled like a HVAC device and will also be detected as one. You can set the settings of the Z-Wave device through the Z-Wave control panel. Sometimes this is noted in the device manual. These devices will either show as a binary sensor or a sensor called Alarm xxxx and will report a numeric value. In order for Home Assistant to recognize motion or alarm sensors properly, you will need to change the sensor configuration from Basic Set (default) to Binary Sensor report or Alarm report. There is currently support for the following device types within Home Assistant: Click the “Add integration” button in the bottom right and from the list of integrations, select “Z-Wave” and follow the instructions shown.įor more information, please see the detailed installation instructions. Then Go to Configuration > Integrations in the UI. To add Z-Wave to your installation, plug the Z-Wave stick into the device that runs Home Assistant. The Z-Wave integration for Home Assistant allows you to observe and control connected Z-Wave devices. The technical dependencies may render this integration unusable in the future at which time it may be removed.
The Z-Wave integration will no longer receive any updates. We recommend using the Z-Wave JS integration.
0 kommentar(er)
